Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
Got a credit card? use our Credit Card & Finance Calculators
Thanks to Wasron,jfgw,Rhyd6,eyeball08,Wondergirly, for Donating to support the site
Internal Doors
-
- Lemon Quarter
- Posts: 2300
- Joined: November 4th, 2016, 4:20 pm
- Has thanked: 1899 times
- Been thanked: 870 times
Re: Internal Doors
Most internal doors can be trimmed a little for width and height.
The hollow ones perhaps less so, but if you check the spec it should tell you how much.
Thickness is often less of an issue, a slight difference either way might not be noticeable.
The hollow ones perhaps less so, but if you check the spec it should tell you how much.
Thickness is often less of an issue, a slight difference either way might not be noticeable.
-
- Lemon Half
- Posts: 6100
- Joined: November 21st, 2016, 4:26 pm
- Has thanked: 443 times
- Been thanked: 2344 times
Re: Internal Doors
Andy46 wrote:Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
See previous thread.
viewtopic.php?f=40&t=28407
As I said then, consider addressing the adjustment to the "hole" not the door.
-
- Lemon Half
- Posts: 7383
- Joined: February 7th, 2017, 9:36 pm
- Has thanked: 10514 times
- Been thanked: 4659 times
Re: Internal Doors
dealtn wrote:Andy46 wrote:Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
See previous thread.
viewtopic.php?f=40&t=28407
As I said then, consider addressing the adjustment to the "hole" not the door.
There are other alternatives on the same thread and dealtn has correctly pointed you in that direction.
AiY
-
- 2 Lemon pips
- Posts: 242
- Joined: November 12th, 2016, 1:47 pm
- Has thanked: 104 times
- Been thanked: 10 times
Re: Internal Doors
Hi
Thanks. I knew i'd posted that but couldn't find it. I obviously didn't look very hard
Thanks again
Thanks. I knew i'd posted that but couldn't find it. I obviously didn't look very hard
Thanks again
Who is online
Users browsing this forum: No registered users and 22 guests