Page 1 of 1
Internal Doors
Posted: September 26th, 2021, 2:51 pm
by Andy46
Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
Re: Internal Doors
Posted: September 26th, 2021, 3:31 pm
by staffordian
Most internal doors can be trimmed a little for width and height.
The hollow ones perhaps less so, but if you check the spec it should tell you how much.
Thickness is often less of an issue, a slight difference either way might not be noticeable.
Re: Internal Doors
Posted: September 26th, 2021, 7:52 pm
by dealtn
Andy46 wrote:Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
See previous thread.
viewtopic.php?f=40&t=28407As I said then, consider addressing the adjustment to the "hole" not the door.
Re: Internal Doors
Posted: September 26th, 2021, 9:06 pm
by AsleepInYorkshire
dealtn wrote:Andy46 wrote:Hi,
I'm looking to get some new internal doors. My current doors are 1975mm D x 780 H x 35mm D
Unfortunately these seem to be a none standard size. Is there any cheaper option other than purchasing bespoke made doors?
Thanks
Andy
See previous thread.
viewtopic.php?f=40&t=28407As I said then, consider addressing the adjustment to the "hole" not the door.
There are other alternatives on the same thread and dealtn has correctly pointed you in that direction.
AiY
Re: Internal Doors
Posted: September 26th, 2021, 9:57 pm
by Andy46
Hi
Thanks. I knew i'd posted that but couldn't find it. I obviously didn't look very hard
Thanks again